PWM to 0-5V Voltage and on/off switch Converter Module

$20.00

PWM to Voltage and on/off switch Converter Module. PWM to voltage output D/A converter converts a PWM input to an accurate, stable, linear 0-5v voltage without the ripple, slow settling, and external passive components of discrete filter implementations.

Compare
SKU: PTW2 Category:

Description

This module is designed for Remote control(radio control) big power bldc motors with its controller. The PWM to voltage converter has 4 chanels from RC receiver to transfer PWM signals. You can use them according to yor transmitter. General function as follows:

  1. P1 to DIR1: on/off switch relay. When PI has signal input, the Com1 and NC1 from DIR1 will be on as a on-off. It can be used for braking switch, reverse switch and so on.
  2. P2 to OUT1:  PWM Signal from P2 to OUT1: Vout1 will output 0-5V voltage according to the transmitter joystick from bottom to top or top to bottom. The Vout1 and GND to motor controller throttle single wire and GND. This will adjust the motor speed via transmitter joystick.
  3. P3 to OUT2: PWM Signal from P3 to OUT2: Vout2 will output 0-5V voltage according to the transmitter joystick from middle to top(right) or bottom(left). The Vout1 and GND to motor controller throttle single wire and GND. This will adjust the motor speed via transmitter joystick.
  4. P4 to DIR2: on/off switch relay. When P4 has signal input, the Com2 and NC2 from DIR2 will be on as a on-off. It can be used for braking switch, reverse switch and so on.
PWM to voltage module wires diagram
above is PWM from RC receiver to voltage module wires diagram

 

Additional information

Weight1 kg

Reviews

There are no reviews yet.

Be the first to review “PWM to 0-5V Voltage and on/off switch Converter Module”

Your email address will not be published. Required fields are marked *