multi-function RS485 CAN encoder dual control servo motor driver

(1 customer review)


It is also can be controlled by ADC , which is use throttle to control speed and more interesting function is that this new driver supports RC controller, but you need to buy RC your self.

The driver or dual drive controller can control two motors or one motor if you like, and even four motors by two drivers. It can work with encoder motors or even a common hall sensors brushless motors. It is programable, we have PC program software.

SKU: SVD48 Category:


SVD48V30A price is USD160, SVD48V50 Price is USD180. Please noted the price does not include RS232-USB cable.

The user guide and user manual please refer to there

Operating Voltage24V-48VDC24V-48VDC
Maximum input continuous current20A40A
Output highest Iq current30A50A
Adapted motor power100-400W400-800W
Minimum RPM Support1.0RPM
Minimum working voltage18V
Maximum working voltage60V
Overvoltage Protection ThresholdSoftware settings
control modeSpeed mode, position mode, torque mode
control interfaceRS485, RS232, CAN, PWM, analog input
Host computer supportSV-Config programming software, RS232 interface
Encoder inputA/B/Z type, A/B+HALL type, Hall sensor type
Working temperature-20℃ ~ +55℃
Dimensions143 x 80 x 33 mm

You can use such RC to control the driver.


Additional information

Weight1 kg

1 review for multi-function RS485 CAN encoder dual control servo motor driver

  1. Fritz

    It seems like a nice servo drive, but your documentation is lacking.
    What is the pinout of the “power switch connector”? It is not mentioned in the manual, and it has four pins instead of an expected two pins.
    Why does the “power switch connector” come with a small capacitor attached from the factory? How can it be used, or how is it intended to be used?
    If using the “emergency stop” on the extension connector, what ways are available to bring the controller back to running state? What are the limitations of emergency stop?

Add a review

Your email address will not be published. Required fields are marked *