dual control PWM to Voltage Converter Module for e bike motor controller

$30.00

dual drive control PWM to Voltage and on/off switch Converter Module. PWM to voltage output D/A converter converts a PWM input to an accurate, stable, linear 0-5v voltage without the ripple, slow settling, and external passive components of discrete filter implementations. It can control motor turnning left or right.

Compare
SKU: PTW1 Category:

Description

This dual drive module is designed for Remote control(radio control) big power e bike motor with its controller. The PWM to voltage converter has 2 chanels from RC receiver to transfer PWM signals. You can use them according to yor transmitter. General function as follows:

  1. P1 input controls DIR1 and OUT1. Joystick from transmitter at middle postion, Vout1 voltage is 0V, . When joystick is pushed to top(left) or bottom(right), Vout1 output 0-5V voltages. The Vout1 and GND to motor controller throttle single wire and GND. This will adjust the motor speed via transmitter joystick.
  2. When P1 has signal input, the Com1 and NC1 from DIR1 will be on as a on-off. It can be used for braking switch, reverse switch and so on.
  3. P2 input controls DIR2 and OUT2.: PWM Signal from P3 to OUT2: Vout2 will output 0-5V voltage according to the transmitter joystick from middle to top(right) or bottom(left). The Vout1 and GND to motor controller throttle single wire and GND. This will adjust the motor speed via transmitter joystick.
  4. P2 to DIR2: on/off switch relay. When P2 has signal input, the Com2 and NC2 from DIR2 will be on as a on-off. It can be used for braking switch, reverse switch and so on.

 

Additional information

Weight1 kg

Reviews

There are no reviews yet.

Be the first to review “dual control PWM to Voltage Converter Module for e bike motor controller”

Your email address will not be published. Required fields are marked *